What we call "radiator water" is not actually water but coolant: a mixture of antifreeze and distilled water. This fluid carries engine heat to the radiator; if it is not chosen correctly and changed on time, the radiator, water pump and heater core deteriorate from the inside.
Can you use plain water in a radiator?
You should not. Antifreeze has three jobs:
- Prevents freezing: Water expands when it freezes in winter and can crack the radiator, engine block and hoses.
- Raises the boiling point: Together with the pressurised system, it delays boiling in summer heat.
- Protects: Its additives prevent rust, limescale and deposits, and lubricate the water pump seal.
In a system running on plain water, deposits build up within a few years. These deposits block the fine tubes of the radiator and heater core; a radiator that looks sound from the outside can no longer cool the coolant.
What should the antifreeze ratio be?
For most vehicles the recommended mix is roughly half antifreeze and half distilled water. The exact ratio and freeze protection are stated in the vehicle handbook and on the antifreeze packaging. In very cold regions the antifreeze ratio can be increased; however, if it is raised more than necessary, the fluid's heat-transfer capacity drops. No water should be added to pre-mixed (ready-to-use) antifreeze.
Use distilled (purified) water in the mix. The limescale and minerals in tap water form deposits in the system.
Can different antifreeze colours be mixed?
Colour alone does not indicate the type of antifreeze; different manufacturers may sell the same type in different colours. What matters is the chemical type of the antifreeze (the standard specified in the vehicle handbook). Mixing different types can cause the additives to cancel each other out and lead to deposits. If you do not know which antifreeze is in the system, the safest course is to drain it and refill with the type the vehicle requires rather than topping up.
When should radiator coolant be changed?
The change interval depends on the antifreeze type and the vehicle handbook; it is given as a number of years or a certain mileage. A change is needed before the interval is up in the following cases:
- The fluid looks cloudy, rusty or brown.
- There is an oily layer in the expansion tank (this may indicate a gasket or oil cooler fault).
- The radiator, water pump or heater core has been replaced.
- The vehicle has been driven for a while with only water added to the system.
What to do if coolant is being lost?
The cooling system is a closed circuit; regular coolant loss is not normal. If it is going down, it is either leaking somewhere or being burnt internally. The causes and how to tell them apart are covered in our article no overheating but losing coolant.
If you need to top up lost coolant on the road:
- Do not open the expansion tank or radiator cap before the engine has cooled; the system is under pressure.
- In an emergency, distilled water can be added; the mix ratio should then be corrected with antifreeze.
- Do not pour cold water into a hot engine; the sudden temperature difference can damage it.
How do you check the level?
With the engine cold, the fluid in the expansion tank should be between the "MIN" and "MAX" lines. The level rises when the engine is hot; always check with the engine cold.
Frequently asked questions
Can tap water be put in a radiator?
It is not recommended. The limescale and minerals in tap water form deposits in the system. If it has been used in an emergency, the system should be drained at the first opportunity and refilled with antifreeze and distilled water.
Is antifreeze needed in summer too?
Yes. Antifreeze does not only prevent freezing; it raises the boiling point and protects the system against rust. Running on plain water in summer increases the risk of overheating and deposits.
Why does radiator coolant go down?
The most common causes are a leak (hose, radiator, water pump, heater core) or internal burning (cylinder head gasket, EGR cooler). When the spring in the radiator cap weakens, the coolant also boils early and overflows.
Should radiator stop-leak be used?
It can be used as a temporary fix for small leaks; however, these additives can also block fine tubes and do not fix the underlying fault. The permanent solution is to repair or replace the leaking part.
On the Engine Cooling Radiator page you can find parts by OE number, size or vehicle. For trade purchases see our wholesale page.