A car heater is not a separate heating unit. The engine coolant passes through the heater core behind the dashboard, and the fan blows the air drawn across the core into the cabin. In other words, the heater's warmth is the engine's heat. If the heater is not warming, either hot coolant is not reaching the core, the core cannot give off its heat, or air is not passing over the core.
First, check the temperature gauge
- Gauge normal, heater cold: The problem is most likely on the cabin side (core, blend door, fan).
- Gauge low, engine slow to warm up: The thermostat may be stuck open. The coolant is constantly cooled in the radiator, so neither the engine nor the heater warms up. Fuel consumption also rises in winter.
- Temperature rising and heater not warming: This is a serious sign. The coolant may be very low, there may be an airlock in the system, or the water pump may not be circulating the coolant. Stop and have the vehicle checked before the engine is damaged.
Common causes
- Low coolant or air in the system: The heater core is usually one of the highest points in the system, so it is the first place to be left with air when the coolant level drops. Topping up the coolant and bleeding the system is often enough.
- Blocked heater core: In systems that have run on plain water for years, or where a leak-sealing additive has been used, the core's narrow channels become clogged with scale and deposits. Symptom: with the engine hot, one of the two hoses running to and from the core is hot while the other is lukewarm or cold.
- Blend door (mixing flap) not working: If the motor or cable of the flap that mixes hot and cold air fails, cold air comes through whatever the setting. Sometimes a clicking noise can be heard from behind the dashboard.
- Heater valve stuck closed: On some vehicles, a valve opens and closes the coolant flow to the core.
- Fan not working, or working only on some speeds: This is a blower resistor or blower motor fault. No air comes through, so it makes no difference that the core is hot.
Can a heater core be cleaned?
With light blockages, the core can be back-flushed by removing its hoses and running water through it in reverse, or cleaned with a suitable chemical. If scale and deposits have settled firmly in the core's channels, cleaning will not give a lasting result and the core must be replaced. After cleaning, deposits in the radiator and engine can return to the core, so flushing the entire cooling system and renewing the antifreeze is recommended.
If the heater core is leaking
Dampness under the front floor mat, an oily mist forming on the inside of the windows and a sweetish smell in the cabin indicate a leaking core. In this case the core must be replaced. On some vehicles, reaching the core requires removing the dashboard; to get the right part first time, check the OE number or dimensions of the old core.
You can find heater cores to fit your vehicle on our heater core page by OE number, dimensions or vehicle.
On the Heater Core (Heater Matrix) page you can find parts by OE number, size or vehicle. For trade purchases see our wholesale page.